Intrepid V6-3.2L VIN J (1998)
NOTE:
If the recliner paddle hole and seat frame hole are not aligned, rotate the recliner paddle until the holes are aligned and the paddle flat is
parallel with the seat back frame.
NOTE:
If the seat back frame threads are stripped, tighten the bolt as much as possible and then install and tighten the nut.
IMPORTANT:
Use the proper size torque wrench. Do NOT over tighten. Do not use a foot-pound torque wrench.
15.
In stall the remaining nut onto the bolt (Figure 8). While holding the bolt stationary, tighten the nut to 110 in-lbs (12.5 N.m).
16.
Install the seat side shield~ Tighten the screws securely.
17.
Tip the driver's seat assembly back into position and then install the headrest.
18.
Fully recline the seat back to verify proper operation. If the seat back twists while moving, the flexshaft was not properly installed. Repeat
Steps 8 and 9 to reinstall the flexshaft. Return the seat back to the upright position.
19.
Install the two (2) front driver's seat anchor bolts. Tighten the bolts to 45 ft-lbs (61 N.m).
20.
Move the driver's seat to the forward-most position.
21.
Install the two (2) rear driver's seat anchor bolts. Tighten the bolts to 45 ft-lbs (61 N.m).
22.
Return the driver's seat to its original position and then return the vehicle to the customer.
