Intrepid V6-3.2L VIN J (1998)
NOTE: Step 1 below is only required when installing a caliper after new brake shoes have been installed.
1. Completely retract caliper piston back into piston bore of caliper assembly.
2. Lubricate both steering knuckle abutments with a liberal amount of Mopar Brake Grease for Caliper Slides Lubricant, or equivalent.
3. Remove the protective paper from the noise suppression gasket on both the inner and outer brake shoe assemblies (if equipped).
NOTE:
Front Brake Shoe Assembly Identification
-
The inboard and outboard brake shoes are not common, refer to image for inboard and outboard brake shoe assembly identification.
-
When installing inboard brake shoe into caliper piston, be sure brake shoe is positioned squarely against the face of the caliper piston.
4. Install the new inboard brake shoe assembly into the caliper piston by firmly pressing it into bore of caliper piston with thumbs.
Installing Outboard Brake Shoe
5. Slide the new outboard brake shoe assembly onto the caliper assembly.
