Intrepid V6-3.2L VIN J (1998)
CAUTION: When being installed, extreme caution should be taken not to cross-thread the caliper guide pin bolts.
5. Install the caliper guide pin bolts. Tighten guide pin bolts to a torque of 22 Nm (192 inch lbs.).
6. Install the wheel and tire assembly.
7. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 129 Nm (95 ft. lbs.).
8. Remove jackstands or lower hoist. Before moving vehicle, pump the brake pedal several times to insure the vehicle has a firm brake pedal to
adequately stop vehicle..
WARNING: Before moving vehicle after performing any service to the vehicle brake system, be sure to obtain a firm brake pedal.
9. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoe linings.
Rear
GENERAL INFORMATION
During service procedures, grease or any other foreign material must be kept off brake shoe assemblies, and braking surfaces of rotor.
Handling of the rotor and caliper, must be done in such a way as to avoid damage to the rotor and scratching or nicking of lining on the brake
shoes.
If inspection reveals that the caliper piston seal is leaking, it MUST be replaced immediately.
During removal and installation of a wheel and tire assembly, use care not to strike the caliper.
REMOVE
1. Raise vehicle on jackstands or centered on a hoist.
2. Remove rear wheel and tire assemblies from vehicle.
Removing Caliper Guide Pin Bolts
3. Remove the 2 caliper assembly to adapter guide pin bolts.
