Intrepid V6-3.2L VIN J (1998)
Parking Brake Lever: Service and Repair
Parking Brake Lever Removal
NOTE: The park brake lever assembly on this vehicle is serviced with the front cable installed on it. They should be removed, replaced, and installed as
an assembly.
Correctly Isolated Remote Ground Cable
1. Remove remote ground cable from ground stud on shock tower. Then correctly isolate ground cable from vehicle by installing isolator on stud.
2. Raise the vehicle using a frame contact type hoist or correctly supported on jackstands.
3. Loosen the park brake tensioner adjuster nut, in front of the rear crossmember, until tension is removed from cables.
4. Disconnect the cable connector between the front and intermediate cable.
5. Lower the vehicle to the ground.
6. Remove the driver's door opening sill cover.
7. Remove the driver's side kick panel.
Fuse Panel Cover
8. Remove the fuse panel cover from the left end of the instrument panel.
