Intrepid V6-3.2L VIN J (1998)
Reinforcement Attachment To Vehicle
5. Remove the 8 bolts, attaching the reinforcement to the strut towers and the 1 bolt attaching the wiper module to the reinforcement. Remove the
reinforcement from the vehicle.
6. Disconnect the wire connector from the brake fluid level sensor on the right side of the master cylinder reservoir.
Master Cylinder Mounting
7. Remove the 2 nuts attaching the master cylinder to the vacuum booster.
Master Cylinder Positioning
8. Carefully slide master cylinder off vacuum booster with brake lines attached, and position it backwards, on top of left engine cylinder head cover.
9. Disconnect vacuum hose from power brake booster check valve. DO NOT REMOVE CHECK VALVE FROM POWER BRAKE BOOSTER.
10. From under instrument panel, position a small screwdriver between the center tang on the power brake booster input rod to brake pedal pin
retaining clip.
11. Rotate screwdriver enough to allow retainer clip center tang to pass over end of brake pedal pin and pull retainer clip off pin. Discard retainer clip
it is not to be reused, replace only with a new retainer clip.
12. Remove the four nuts that attach the vacuum booster to the vehicle dash panel. Nuts are accessible from under the dash panel in the area of the
steering column and pedal bracket.