Intrepid V6-3.2L VIN J (1998)
NOTE: Do not reuse V-Band clamp.
7. Remove electrical connector harness bracket.
8. Disconnect oxygen sensor electrical connector and remove sensor from manifold.
9. Remove heat shield attaching bolts and remove heat shield.
10. Remove manifold attaching bolts.
11. Remove manifold.
Installation
1. Install exhaust manifold. Tighten bolts starting at the center working outward to 23 Nm (200 inch lbs.).
2. Install heat shields and tighten bolts to 12 Nm (105 inch lbs.).
3. Install oxygen sensor to manifold and connect electrical connector.
4. Attach electrical connector bracket to brace.
5. Install a new V-Band clamp and tighten to 11 Nm (100 inch lbs.).
6. Raise vehicle on hoist.
7. Install and/or tighten nut attaching converter pipe supports to transaxle brackets to 47 Nm (35 ft. lbs.).
8. Install exhaust system.
9. Lower vehicle and connect negative cable.
