Intrepid V6-3.2L VIN J (1998)
4. Remove the CAB from the HCU.
INSTALL
1. Install the CAB on the HCU.
2. Install the 4 bolts mounting the CAB to the HCU. Tighten the CAB mounting bolts to a torque of 2 Nm (17 inch lbs.).
3. Plug the pump/motor wiring harness into the CAB.
4. Install the ICU.
NOTE: The ICU may need to be initialized, using the DRB scan tool, after ICU installation.
5. Bleed the base brakes and the ABS brakes hydraulic system.
6. Road test vehicle to ensure proper operation of the base and ABS brake systems.
