Intrepid V6-3.2L VIN J (1998)
20. Install the wiper arms on the pivots. Install and securely tighten the wiper arm to pivot attaching nuts. Install the caps on the wiper arms covering
the pivot nuts.
Battery Ground Cable At Shock Tower
21. Install the battery ground cable onto the ground stud on the shock tower.
CAUTION: Do not use automatic transmission fluid. Use only the proper Mopar (R) Power Steering Fluid or equivalent when filling the power
steering fluid reservoir.
22. Fill the power steering fluid reservoir to the correct full cold level.
23. Start the engine and let run for a few seconds and the shut the off.
24. Add power steering fluid the power steering fluid reservoir to fill it to the correct cold fill level.
25. Start engine and turn steering wheel several times from stop to stop to bleed air from fluid in system. Stop engine, check fluid level, and inspect
system for leaks. Fill pump reservoir to correct level with Mopar (R), Power Steering Fluid, or equivalent. See Checking Fluid Level.
26. Lower vehicle.
27. Adjust toe. Refer to Alignment.