Intrepid V6-3.2L VIN J (1998)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley Replacement
CAUTION: When mounting the power steering pump in the vise do not clamp the pump in the vise by the body of the power steering pump.
DISASSEMBLE
1. Mount the power steering pump in a vise using the mounting bosses for the power steering pump.
NOTE: Do not press or hammer on the shaft of the power steering pump in an attempt to remove the pulley. This will damage the internal
components of the power steering pump.
2. Remove the power steering pump pulley from the power steering pump shaft using Puller, Special Tool C-4333, or equivalent.
NOTE: Do not press or hammer on the shaft of the power steering pump in an attempt to install the pulley. This will damage the internal components of
the power steering pump.
ASSEMBLE
1. Place the power steering pump pulley on the end of the power steering pump shaft. Make sure the pulley is installed squarely on the end of the
shaft.
CAUTION: When installing the pulley on the power steering pump, Spacer Special Tool 6936, or equivalent MUST be used. The spacer
provides for the correct pulley location on the power steering pump to provide correct accessory drive belt alignment. The alignment is critical in
controlling accessory drive belt noise. It also prevents the pulley from contacting the power steering pump when it is installed, causing power
steering pump or pulley damage.
Spacer Installed In Power Steering Pump Pulley
2. Install Spacer Special Tool 6936, or equivalent into the hub of the power steering pump pulley.
