Intrepid V6-3.2L VIN J (1998)
the fuel filler tube.
18. Install the lateral link attaching nuts, but DO NOT fully tighten at this time.
CAUTION: Tightening the lateral link attaching bolts at this time will cause the bushings contort at curb riding height, leading to premature
failure of the bushings. Tighten bolts only when vehicle is at curb riding height.
19. Install wheel and tire assemblies on vehicle.
20. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 129 Nm (95 ft. lbs.).
21. Lower vehicle to the ground.
22. Install the 3 fuel filler neck attaching screws. Reinstall the fuel filler cap.
23. Tighten all 4 lateral arm to crossmember attaching bolt and nut assemblies to 95 Nm (70 ft. lbs.).
24. Check and reset rear wheel TOE to specifications if required.
