Intrepid V6-3.2L VIN J (1998)
3. Install the lateral links on the spindle. Install, but DO NOT fully tighten the attaching bolt and nut at this time.
4. Install rear wheel and tire assembly on vehicle.
5. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 129 Nm (95 ft. lbs.).
6. Lower vehicle to the ground.
7. Tighten lateral arm to crossmember attaching bolt and nut to 95 Nm (70 ft. lbs.).
8. Tighten lateral arm to spindle attaching bolt and nut to 135 Nm (100 ft. lbs.).
9. Check and reset rear wheel TOE to specifications if required.
