Intrepid V6-3.2L VIN J (1998)
Disc Brake Adapter Mounting
4. Install the disc brake adapter back on the spindle. Install the 4 bolts attaching the disc brake adapter to the rear spindle. Tighten the disc brake
adapter mounting bolts to a torque of 115 Nm (85 ft. lbs.).
Wheel Speed Sensor At Adapter
5. If vehicle is equipped with antilock brakes, install the speed sensor head into the rear disc brake adapter. Tighten the speed sensor head attaching
bolt to a torque of 7 Nm (60 inch lbs.).
Rear Hub And Bearing Retaining Nut Removal
6. Install the rear hub and bearing assembly on the rear spindle. Install hub and bearing assembly retaining washer and nut on spindle. Tighten the
hub and bearing retaining nut to a torque of 168 Nm (124 ft. lbs.).
7. Install the rear brake disc on the hub.
8. Carefully place rear brake caliper over rotor and install on adapter. Tighten the caliper assembly to adapter mounting bolts to a torque of 22 Nm
(192 inch lbs.). Refer to Brakes and Traction Control for required caliper installation procedure.
9. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
