Intrepid V6-3.2L VIN J (1998)
11. Remove the lateral links from the spindle. This requires the removal of one long bolt attaching both links to the spindle.
Link Attachment To Stabilizer Bar
12. Install a thin wrench on the hex of the stabilizer bar attaching link stud to keep the stud from turning in the link. Next, remove the nut from the
stabilizer bar attaching link stud at the stabilizer bar. Remove the link from the stabilizer bar.
Spindle To Strut Assembly Pinch Bolt
13. Loosen and fully remove, the rear spindle to strut assembly pinch bolt.
CAUTION: When inserting center punch into rear spindle, use care so point of center punch does not puncture strut assembly.
Center Punch Installed In Spindle
14. Insert a center punch into the hole on the spindle. Center punch must be tapped into spindle until jammed into hole. This will spread spindle
casting allowing it to be removed from strut assembly.