dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Front Strut(s) - Squeaking Noise|Page 6331 > < Front Strut(s) - Squeaking Noise
Page 1
background image

Suspension Strut / Shock Absorber: All Technical Service Bulletins
Front Strut(s) - Squeaking Noise

NUMBER: 02-01-00

GROUP: Suspension

DATE: Feb. 4, 2000

THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 02-12-98 DATED
OCTOBER 30,1998, AND SHOULD BE NOTED IN THE 1998 TECHNICAL SERVICE
BULLETIN MANUAL (PUBLICATION NO.81-699-99003). THE PARTS AND
PROCEDURE ARE COMPLETELY REVISED.

SUBJECT:
Squeaking Noise Coming From Front Strut(s)

OVERVIEW:
This bulletin involves a revised front strut striker cap.

MODELS:
1998 - 2000 (LH) Concorde/Intrepid/LHS/300M

SYMPTOM/CONDITION:
Squeaking noise from front strut(s) during suspension jounce.

DIAGNOSIS:
Bounce vehicle so that the front struts are in the full jounce position or drive the vehicle over speed bumps at 8-10 mph. If a squeaking or percolating
(similar to old coffee maker) noise can be heard coming from either front strut, perform the Repair Procedure.

PARTS REQUIRED:
2

05018266AA 

Cap, Strut Striker

REPAIR PROCEDURE:

1. Remove and disassemble the front struts of the 2000 Concorde/Intrepid/LHS/300M Service Manual (Publication No.81-270-0040).

2. Remove the strut striker cap by prying upward, first on one side then the other, until the cap is free of the strut housing and can be slid off the strut

shaft.

3. Install the revised strut striker cap by sliding it over the strut shaft until it contacts the strut housing. Gently tap the cap into place until it is fully

seated on the strut housing.

4. Assemble the strut and install it into the vehicle as described of the 2000 Concorde/Intrepid/LHS/300M Service Manual (Publication

No.81-270-0040).

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:
Labor Operation No:

02-05-37-92

1.5 Hrs.

FAILURE CODE: P8 - New Part

Front Strut(s) - Squeaking Noise|Page 6331 > < Front Strut(s) - Squeaking Noise