Intrepid V6-3.2L VIN J (1998)
Power Window Switch: Service and Repair
Rear Door Power Window Switch Replacement
REMOVAL
Negative Battery Cable Remote Terminal
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Open rear door.
3. Using a trim stick (special tool #C-4755), gently pry up on rear edge of switch pushing forward as you pry up on switch bezel.
4. Pull switch up and out of rear door trim panel.
5. Using a trim stick, gently pry out on retaining tabs on side of switch connector and pull connector from switch.
6. Remove switch from vehicle.
INSTALLATION
-
For installation, reverse the above procedures.