Intrepid V6-3.2L VIN J (1998)
Wiper Arm: Service and Repair
Wiper Arm and Blade
REMOVAL
1. Cycle the wiper arm/blades into PARK position and turn ignition OFF.
2. Using a trim stick (special tool #C-4755), gently pry up on the wiper arm retaining nut cap and remove.
3. Remove the retaining nut from the wiper arm pivot.
4. Lift wiper arm to raise blade off glass and remove the arm from the pivot using a rocking motion and remove from vehicle.
INSTALLATION
-
For installation, reverse the above procedures.
-
Refer to Wiper Arm Adjustment for adjustment procedures.
