Intrepid V6-3.5L VIN K (2003)
Remote Switch: Testing and Inspection
DIAGNOSIS AND TESTING - REMOTE SWITCHES
Any diagnosis of the Audio system should begin with the use of the DRB III(R) diagnostic tool.
Refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, details of
wire harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds.
WARNING: DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT
TENSIONER, SIDE AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR- BAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
Fig.11 Remote Radio Switches
Remote Radio Switch Test Part 2
1. Disconnect and isolate the battery negative cable. Remove the remote radio switch (es) from the steering wheel.
Remote Radio Switch Test
2. Use an ohmmeter to check the switch resistances as shown in the Remote Radio Switch Test table. If the remote radio switch resistances check
OK, go to Step 3. If not OK, replace the faulty switch.
