Intrepid V6-3.5L VIN K (2003)
Fig.13 Front Door Trim Panel - Typical
2. Remove speaker grille by inserting trim tool at the rear of the grille and disengaging tabs holding to trim panel. Remove grille.
3. Open trim plug from the pull cup and remote bezel by inserting a small flat blade tool into the notch and lifting up.
4. Remove three screws from bottom of door.
5. Remove screw in pull cup.
6. Remove screw in remote bezel.
7. Remove two screws in the instrument panel interface area.
8. Remove three screws in the speaker area.
NOTE: Door trim clips are reusable up to three times, then should be replaced.
9. Using a trim tool, disengage the two retainer clips at rear of panel from the door trim panel to the sheet metal inner panel.
10. Raise trim panel up to disengage from the belt being careful to hold the panel securely.
NOTE: Failure to hold the door trim panel before disengagement of the linkage will result in remote handle damage.
