Intrepid V6-3.5L VIN K (2003)
Power Seat Switch: Service and Repair
Driver Power Seat Switch Replacement
REMOVAL
1. Open hood, disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: SOME VEHICLES ARE EQUIPPED WITH SEATBACK MOUNTED AIRBAGS. BEFORE ATTEMPTING TO DIAGNOSE
OR SERVICE ANY SEAT OR POWER SEAT SYSTEM COMPONENT YOU MUST FIRST DISCONNECT AND ISOLATE THE
BATTERY NEGATIVE CABLE. THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE FURTHER
SYSTEM SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO DO SO COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
Fig.4 Power Seat Switch And Seat Side Shield
2. Remove seat cushion side shield. Refer to the Body section for the procedure.
3. Disconnect wiring from switch.
Fig.5 Removing Switch Control Knobs - Typical
4. Remove knobs from the switch.
5. Remove switch attaching screws.
6. Remove switch from cushion side shield
INSTALLATION
1. Position the switch and install the switch attaching screws.
2. Install the knobs on the switch.