Intrepid V6-3.5L VIN K (2003)
Reservoir Sealing Grommets
7. Remove the master cylinder housing-to-reservoir grommets.
8. For reassembly, Refer to MASTER CYLINDER -ASSEMBLY.
ASSEMBLY
1. Install new housing-to-reservoir grommets in master cylinder housing.
2. Lubricate brake fluid reservoir-to-grommet mounting area with clean brake fluid. Place reservoir in position over grommets. Seat reservoir into
sealing grommets using a rocking motion while pushing down on reservoir.
3. Make sure bottom of reservoir touches the top of both sealing grommets.
4. Install the 2 fluid reservoir to master cylinder retaining pins.
5. Bleed and install master cylinder on vehicle.