Intrepid V6-3.5L VIN K (2003)
1. If not already installed, install, but do not tighten, the one bolt in the junction block bracket.
2. Install the junction block with mounting bracket onto the engine cradle crossmember guiding the installed bolt into the slot in the engine cradle
crossmember.
3. Align the remaining mounting bolt hole in the junction block bracket with its mounting hole in the engine crossmember and install, but do tighten,
the remaining mounting bolt.
4. Tighten the first mounting bolt (installed in engine cradle crossmember slot) to 26 Nm (230 inch lbs.) torque with the aid of a crow foot wrench.
5. Lower the vehicle to the ground.
6. Tighten the remaining junction block bracket to-engine cradle crossmember mounting bolt to 26 Nm (230 inch lbs.) torque.
7. Install the four chassis brake tubes (going to each brake) to the junction block. Tighten the tube fittings to 17 Nm (145 inch lbs.) torque with the
aid of a crow foot wrench.
8. Install the two brake tubes coming from the primary and secondary master cylinder ports to the top rear corners of the junction block. Tighten the
tube fittings to 17 Nm (145 inch lbs.) torque with the aid of a crow foot wrench.
9. Install the transmission control module (with speed control servo attached) in its normal position. Install the nut and screw securing it in place
10. Install the transmission control module mounting nut and screw securing it in place. Tighten the screw to 6 Nm (45 inch lbs.). Tighten the nut to
12 Nm (107 inch lbs.) torque.
11. Install the screw attaching the washer filler tube to the upper radiator closure panel.
12. Install the screw attaching the speed control servo to the upper radiator closure panel.
13. Remove the brake pedal holding tool.
14. Bleed the base brake system.
