Intrepid V6-3.5L VIN K (2003)
Crankshaft Main Bearing: Procedures
CRANKSHAFT MAIN BEARING FITTING
The main bearings are a "select fit" to achieve proper oil clearances. For main bearing selection, the block and crankshaft have grade identification
marks.
Grade Marks / Cylinder Block
The marks for the cylinder block main bore grade are located on the left side pan rail, just rear of the left engine mount bracket (Fig. 65). These grade
marks (1, 2, or 3) are read left to right, corresponding to main bore 1, 2, 3, 4.
Grade Marks / Crankshaft
The grade marks for the crankshaft are located on the rear most crankshaft counter weight as shown in (Fig. 66). The crankshaft journal grade marks (A,
B. or C) are read left to right, corresponding with journal number 1, 2, 3, 4.
Refer to the MAIN BEARING SELECTION to properly select the main bearings. For an example, if the main bore grade is 3 and the journal grade is B.
the proper select fit bearing would be a (2) +0.003 mm (+0.0002 in.).
