Intrepid V6-3.5L VIN K (2003)
Intake Manifold: Service and Repair
Upper Intake Manifold
INTAKE MANIFOLD UPPER
REMOVAL
1. Disconnect negative cable from remote jumper terminal.
2. Disconnect the Inlet Air Temperature (IAT) Sensor connector. Remove air cleaner housing and inlet hose (Fig. 121).
3. Remove throttle and speed control cables from throttle arm and bracket.
4. Disconnect electrical connectors from the following sensors and actuators:
-
Short Runner Valve (SRV) (If Equipped)
-
Manifold Tuning Valve (MTV) (If Equipped)
-
Throttle Position Sensor (TPS)
-
Idle Air Control (IAC)
-
Manifold Absolute Pressure (MAP)
5. Disconnect vacuum hoses from the following:
-
Speed Control Reservoir
-
Positive Crankcase Ventilation (PCV) Valve
-
Proportional Purge Solenoid
-
Power Brake Booster