Intrepid V6-3.5L VIN K (2003)
1. Align the crankshaft sprocket with the TDC mark on oil pump cover (Fig. 152).
2. Align the camshaft sprockets (to reference mark made upon removal) between the marks on the rear covers (Fig. 144).
3. Install the timing belt starting at the crankshaft sprocket going in a counterclockwise direction (Fig. 152). Install the belt around the last sprocket.
Maintain tension on the belt as it is positioned around the tensioner pulley.
4. Holding the tensioner pulley against the belt, Install the tensioner into the housing and tighten to 28 Nm (250 in. lbs.). Each camshaft sprocket
mark should still fall between the cover marks.
5. When tensioner is in place pull retaining pin to allow the tensioner to extend to the pulley bracket.
6. Rotate crankshaft sprocket 2 revolutions and check the timing marks on the camshafts and crankshaft. The marks should line up within their
respective locations (Fig. 152). If marks do not line up, repeat procedure.
7. Install the front timing belt covers.
8. Install the crankshaft vibration damper.
9. Install the accessory drive belts.
10. Install the radiator fan.
11. Install upper radiator crossmember.
12. Connect negative cable to remote jumper terminal.
