Intrepid V6-3.5L VIN K (2003)
EGR Tube: Service and Repair
REMOVAL
Fig.8 Bracket And EGR Tube
The EGR tube attaches to the bottom of the intake manifold plenum beside the throttle body.
1. Disconnect negative battery cable.
2. Remove air inlet tube and resonator.
Fig.7 EGR Tube Clips
3. Remove EGR tube mounting clips at intake manifold plenum.
4. Loosen transmission to throttle body bracket. Remove 2 nuts and 1 bolt and remove bracket off of studs.
5. Remove EGR tube mounting screws at EGR valve. When removing EGR upper tube assembly being careful not to drop the silicone rubber seals
in the intake manifold. Clean gasket surfaces on the EGR valve. Note that any loose dirt can lodge between the pintle and the seat and cause valve
leakage that will give a rough idle and depressed manifold vacuum.
6. Remove EGR tube.
INSTALLATION
The EGR tube attaches to the bottom of the intake manifold plenum beside the throttle body.
