Intrepid V6-3.5L VIN K (2003)
Failure to install the SKIM pin number into the module after flashing the PCM will cause a start and stall condition.
5.
If the vehicle is a 2002 LH equipped with the original PCM (as determined by the table above) replace the PCM with part number 05127196AA.
Refer to the service information available in TechCONNECT or the appropriate service manual in Section 8E, Electronic Control Modules,
Powertrain Control Module, Removal/Installation.
6.
Open the hood, install a battery charger and verify battery state is above 11.5 volts.
7.
If the old "PCM part # " is known, proceed to step 13. If the old "PCM part # " is not known, proceed to next step.
8.
On DealerCONNECT select the "Service" tab.
9.
Select "Vehicle Information Plus".
10.
Manually enter the VIN and mileage and select "Enter".
11.
Select the "Vehicle Option" tab.
12.
Under the "Vehicle Option" window, identify and record:
a.
Engine.
b.
Emissions (Federal or California).
c.
Transmission (Automatic, 5-speed manual, etc.).
13.
Connect the DRBIII(R) to TechCONNECT and the vehicle. Open TechTOOLS and verify that the "DRBIII(R) Status: Connected" message is in
the upper right corner of the TechTOOLS screen.
14.
TechTOOLS should automatically populate the VIN in the "Vehicle Criteria" area and the available updates. If not, manually enter the VIN then
TechTOOLS will populate the available updates.
NOTE:
Do NOT enter the generic controller part number in step 15a below.
15.
Determine the proper calibration:
a.
If the old "PCM part # " is known, enter the part number of the old controller in the "Parts Criteria" p/n window. If the vehicle is a 2002 LH
equipped with the original PCM (as determined by the table above) installed use the PCM Part # . per Service Bulletin 18-017-03 as the part
number for the "Parts Criteria" p/n window (refer to column "PCM Part No. per Service Bulletin 18-017-03" from table above). Proceed to
step 16.
b.
If the old "PCM part # " is not known, select the correct calibration based on the information that was recorded from "Vehicle Options" in
step 12.
16.
Select the correct calibration.
17.
Select the "Download/Update" button.
18.
Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT/DRBIII(R).
When the flash process is completed, proceed to next step.
19.
Enter the VIN in the PCM. Using the DRBIII(R) select:
a.
"DRBIII Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All"
d.
"Engine"
e.
"Miscellaneous"
f.
"Check VIN"
