Intrepid V6-3.5L VIN K (2003)
4. Reconnect the power steering hoses at the gear. Tighten both hose tube nuts to 31 Nm (275 in lbs.).
5. Route the solenoid control valve wire harness over the top of the gear and clip it into place on the gear end cap.
6. Connect the wiring harness connector. Be sure the wiring harness connector seal is in good condition before installing the connector in the control
module.
7. Road test vehicle, referring to the test indicated in the Appropriate Diagnostic Information, to confirm correct operation of the variable-assist
speed proportional power steering gear.