Intrepid V6-3.5L VIN K (2003)
23. Using roll pin Remover, Special Tool 6831A, remove roll pin from flex joint of intermediate shaft. Roll pin is removed from coupler using
following procedure:
a. Remove knurled nut from small end of tool.
b. Insert small end of Remover through center of roll pin, then install and hand tighten knurled nut.
c. Position sleeve of removal tool on flex joint as shown.
d. While holding threaded shaft of tool from turning, tighten nut, pulling roll pin out of flex joint.
24. Separate the intermediate steering shaft from the steering gear.
25. Raise vehicle.
26. Remove the right front tire/wheel.
27. Remove the nutattaching the tie rod end to the steering arm on the right strut.
