Intrepid V6-3.5L VIN V (2002)
Fig. 6
2. Remove push pin fasteners attaching bottom of fascia (air dam) to lower crossmember (Fig. 6).
Fig. 7
3. Remove fasteners attaching fascia to splash shields (Fig. 7).
4. Remove push pin fasteners attaching the fascia to upper radiator closure panel.
5. Pull the sides of the fascia outwards to disengage fascia from drive pins then pull fascia forward.
6. Disconnect fog lamp wire connectors, if equipped.
7. Remove fascia from vehicle.
INSTALLATION
1. Connect wire connectors.
2. Place fascia in position on vehicle, by fitting foam to bumper reinforcement. Use care not to scratch fender. Tape may be put on fender for
protection.
3. Install the top center fasteners, to upper radiator closure panel.
4. Align fascia to bumper reinforcement.
5. Align the two fascia studs to the fender vertical attachments, at the same time align the fascia groove on the horizontal flange with the fender
fasteners.
Push fascia rearward to engage the fasteners.
6. Install nut on fascia stud through the splash shield access hole, on each side.
7. Install fasteners attaching fascia to the front fender and splash shield.
8. Install grommet.