Intrepid V6-3.5L VIN V (2002)
Power Seat Switch: Service and Repair
Driver Power Seat Switch Replacement
REMOVAL
Negative Battery Cable Remote Terminal
1. Open hood, disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: SOME VEHICLES ARE EQUIPPED WITH SEATBACK MOUNTED AIRBAGS. BEFORE ATTEMPTING TO
DIAGNOSE OR SERVICE ANY SEAT OR POWER SEAT SYSTEM COMPONENT YOU MUST FIRST DISCONNECT AND
ISOLATE THE BATTERY NEGATIVE CABLE. THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE
BEFORE FURTHER SYSTEM SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO
DO SO COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
Power Seat Switch
2. Remove seat cushion side shield. Refer to the Body section for the procedure.
3. Disconnect wiring from switch.
4. Remove knobs from the switch.
5. Remove switch attaching screws.
6. Remove switch from cushion side shield
INSTALLATION
1. Position the switch and install the switch attaching screws.
2. Install the knobs on the switch.
3. Connect wiring electrical connector on switch.
4. Install the seat cushion side shield. Refer to the Body section for the procedure.
5. Connect the negative battery cable remote terminal on the remote battery post.
