Intrepid V6-3.5L VIN V (2002)
Cruise Control Servo Cable: Service and Repair
REMOVAL
1. Disconnect the negative battery cable.
2. Remove throttle cable bracket from intake manifold.
3. Remove speed control cable from throttle cam by sliding clasp out hole used for throttle cable.
4. Remove the throttle cable (with retaining tab) and then slide cable speed control cable out from bracket.
5. Remove one bolt and two nuts from servo bracket.
6. Disconnect electrical connectors and vacuum hose.
7. Remove two nuts attaching mounting bracket and speed control cable to servo.
8. Pull cable away from servo to expose retaining clip and remove clip attaching cable to servo.
9. Remove servo mounting bracket.
INSTALLATION
1. Slide speed control cable into bracket and with locator positioned into notch in bracket, then slide throttle cable into bracket and engage retaining
tab.
Disconnecting Throttle Cable-Typical
2. Rotate the throttle cam forward to the wide open position and install speed control cable clasp.
3. Rotate the throttle cam forward to the wide open position and install throttle cable clasp.
4. Install throttle cable bracket and tighten bolts.
5. Route cable through bracket and install retaining clip to cable at servo.
6. Insert servo studs through holes in mounting bracket and speed control cable.
7. Install nuts, tighten to 6.7 Nm (60 in. lbs.).
8. Connect vacuum hose to servo.
9. Connect electrical connector.
10. Install servo and bracket and tighten bolts.
11. Connect negative battery cable.
