Intrepid V6-3.5L VIN V (2002)
Lifter / Lash Adjuster: Service and Repair
Lash Adjuster Bleeding
STANDARD PROCEDURE - HYDRAULIC LASH ADJUSTER BLEEDING
Use this procedure to manually bleed aerated oil from the lash adjuster and remove sponginess.
1. Run the engine, bringing it to operating temperature in order to freshly pressurize and warm the valve train system oil supply.
2. Remove cylinder head cover(s).
3. Ensure the rocker arm is positioned on the base circle of the cam (Fig. 37). Rotate engine as necessary.
4. For intake rocker arm positions:
a. Adjust Special Tool 8351 Release Probe's gauge pin to extend approximately 20 mm (0.787 inch). Then, carefully insert the release probe
gauge pin into the lash adjuster service access hole (Fig. 38).
CAUTION: If probe tip breaks off within the lash adjuster, replace the affected rocker arm.
b. Gently unseat lash adjuster's internal check ball.
