Intrepid V6-3.5L VIN V (2002)
Control Module: Service and Repair
Pinion Factor Setting
STANDARD PROCEDURE - PINION FACTOR PROCEDURE
The vehicle speed readings for the speedometer are taken from the output speed sensor. The PCM must be calibrated to the different combinations of
equipment available. Pinion Factor allows the technician to set the Powertrain Control Module initial setting so that the speedometer readings will be
correct.
This procedure must be performed if the Powertrain Control Module has been replaced. Failure to perform this procedure will result in an inoperative
speedometer.
To properly read or reset the Pinion Factor it is necessary to use a DRB scan tool. Perform the following steps with the DRB scan tool to read or reset
the Pinion Factor:
1. Plug the DRB scan tool into the data link connector located under the instrument panel.
2. Select the Transmission menu.
3. Select the Miscellaneous menu.
4. Select Pinion Factor. Then follow the instructions on the DRB scan tool screen.
