Intrepid V6-3.5L VIN V (2002)
the bolt holes in the rack of the steering gear and the steering gear bellows.
12. Align center take-off on steering gear with the tie rod assemblies. Install tie rod attaching bolts and washers into steering gear. Be sure washers are
installed between tie rods and steering gear. Tighten the tie rod-to-steering gear bolts to a torque of 100 Nm (74 ft. lbs.).
CAUTION: After tie rod attaching bolts are torqued, bend retaining plate tabs against heads of attaching bolts.
13. Install the vacuum hose for the vacuum booster on intake manifold vacuum port. Install hose clamp on vacuum hose.
14. Install the master cylinder on the vacuum booster. Install the two nuts attaching the master cylinder to the vacuum booster. Tighten the master
cylinder mounting nuts to a torque of 28 Nm (250 inch lbs.).