Intrepid V6-3.5L VIN V (2002)
16. Align center take off on steering gear with the tie rod assemblies. Install tie rod attaching bolts and washers into steering gear assembly. Be sure
washers are installed between tie rods and steering gear. Tighten the tie rod to steering gear bolts to a torque of 100 Nm (74 ft. lbs.).
CAUTION: After tie rod attaching bolts are torqued, bend the retaining plate tabs against heads of the attaching bolts.
17. Install the vacuum hose for the power brake booster on intake manifold vacuum port. Install hose clamp on vacuum hose.
18. Install the master cylinder on the power brake vacuum booster. Install the two nuts attaching the master cylinder to the booster. Tighten the master
cylinder mounting nuts to a torque of 28 Nm (250 inch lbs.).
19. Connect wire connector to the brake fluid level switch on the side of the master cylinder fluid reservoir.