Intrepid V6-3.5L VIN V (2002)
4. Install the lower control arm to cradle bracket attaching pivot bolt and nut. Do not tighten the lower control arm to cradle bracket attaching bolt at
this time.
5. Install washer on end of tension strut. Install a NEW tension strut to cradle bracket nut, on tension strut. Tighten the tension strut to cradle bracket
retaining nut to a torque of 130 Nm (95 ft. lbs.). When torquing tension strut nut, keep tension strut from turning by holding tension strut at flat
using an open end wrench.
CAUTION:
-
Pulling steering knuckle out from vehicle after releasing from ball joint can separate inner C/V joint. See Driveshafts.
-
When ball joint stud is installed into steering knuckle, do not let ball joint seal hit up against steering knuckle. If ball joint seal hits steering
knuckle, seal damage may occur. If ball joint seal becomes torn, replace seal before assembling lower control arm to knuckle.
