Intrepid V6-3.5L VIN V (2002)
5. If vehicle is equipped with antilock brakes, install the speed sensor head into the rear disc brake adapter. Tighten the speed sensor head attaching
bolt to a torque of 7 Nm (60 inch lbs.).
6. Install the rear hub and bearing assembly on the rear spindle. Install hub and bearing assembly retaining washer and nut on spindle. Tighten the
hub and bearing retaining nut to a torque of 168 Nm (124 ft. lbs.).
7. Install the rear brake disc on the hub.
8. Carefully place rear brake caliper over rotor and install on adapter. Tighten the caliper assembly to adapter mounting bolts to a torque of 22 Nm
(192 inch lbs.).
9. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
10. Lower vehicle to the ground.
11. Tighten the lateral links to spindle attaching bolt to a torque of 135 Nm (100 ft. lbs.).
12. Tighten the trailing arm to spindle bracket attaching bolt to a torque of 100 Nm (75 ft. lbs.).
13. Check and reset rear wheel toe to specifications if required.
