Intrepid V6-3.5L VIN V (2002)
-
Inspect the coil spring for any sign of damage to the coating.
Assembly
ASSEMBLY - STRUT ASSEMBLY (FRONT)
For the disassembly and assembly of the strut assembly, use strut spring compressor, Pentastar Service Equipment (PSE) tool W-7200, or the equivalent,
to compress the coil spring. Follow the manufacturer's instructions closely.
NOTE: If the coil spring has been removed from the spring compressor, proceed with the next step, otherwise, proceed with step 5.
1. Place the coil spring in the compressor following the manufacturers instructions. Before compressing the spring, rotate the spring to the position
noted in the note between steps 7 and 8.
2. If disassembled, reinstall the upper spring isolator and dust shield on seat and bearing. Match the step in the isolator with the step in the seat and
bearing.
3. Install the seat and bearing (with dust shield attached) on top of the coil spring. Position the step built into the seat and upper spring isolator
against the coil end of the coil spring.
