Intrepid V6-3.5L VIN V (2002)
Transmission Cooler: Service and Repair
Transmission Oil Cooler
REMOVAL
The in-tank transmission oil cooler is serviced with the radiator.
For removal of external bans cooler perform the following procedures:
1. Disconnect negative cable from remote jumper terminal.
2. Remove the radiator upper support.
3. Raise vehicle on hoist.
4. Remove right and left front wheels.
5. Remove front fascia.
6. Disconnect the hoses connecting to the external cooler.
7. Remove the radiator side air shields.
8. Remove the screw attaching the cooler line support bracket and remove the bracket.
9. Cut-off the cooler to condenser attaching straps (Fig. 2).
10. Remove the transmission oil cooler and lines (Fig. 2).
CLEANING
Check the external cooler for debris on the cooling fin surfaces. Clean as necessary.
INSPECTION
Inspect all hoses, tubes, clamps and connections for leaks, cracks, or damage. Replace as necessary. Use only approved transmission oil cooler hoses
that are molded to fit the space available.
Inspect external coolers for leaks, loose mounts, or damage. Replace as necessary.
INSTALLATION
For in-tank transmission oil cooler installation, Refer to RADIATOR-INSTALLATION.
For external bans oil cooler installation, perform the following procedures:
