Journey AWD V6-3.5L (2009)
b. Install the flex drive cable into the fore/aft motor (1). Ensure the square cable end is properly aligned and fully inserted into the square drive
slot of the motor assembly (3).
6. Position the flex drive cable cover (2) onto the seat track assembly (4). Ensure the cover slots are properly aligned and fully inserted onto the
mounting tabs (3).
7. Pivot the cable cover towards the cable and onto the fore/aft motor (5).
8. Secure the cover to the motor with the retaining strap (1).
9. Connect the fore/aft motor electrical connector.
10. Install the power seat, See: Service and Repair/Seats, Front/Seat - Installation.
11. Verify proper power seat operation.
Height Adjust Motor
INSTALLATION
1. Screw the height adjust motor gearbox spindle (1) in or out as necessary until the motor retaining screws (3) and spindle screw (4) holes are
aligned and all fasteners can be installed.
2. Position the height adjust motor and gearbox assembly (2) onto the seat track.
3. Install the motor retaining screws (3). Tighten the screws to 12 Nm (106 in. lbs.).
4. Install the height adjust motor gearbox spindle (1) retaining screw (4). Tighten the screw to 17 Nm (150 in. lbs.).
5. Connect the motor electrical connector.
6. Install the power seat, See: Service and Repair/Seats, Front/Seat - Installation.
7. Verify proper power seat operation.
Tilt Motor
INSTALLATION
