Journey AWD V6-3.5L (2009)
brace falling into the rear housing, which may interfere with rear mode door operation.
19. Pull the bottom end of the rear ceiling distribution duct away from the rear heater-A/C housing and remove the duct.
20. Remove the push-pin retainer (2) that secures the rear floor distribution duct (1) to the right inner quarter panel (3).
21. Disengage the rear floor distribution duct from the stud (5) located on the right inner quarter panel.
22. Disengage the rear floor distribution duct from the rear heater-A/C housing (4) and remove the duct.
NOTE: MTC rear heater-A/C system shown. ATC system similar.
23. Disconnect the body wire harness connectors (8 and 9) from the rear blower motor (2) and the rear blower motor resistor or power module (3)
(depending on control system).
24. Disconnect the body wire harness connector (6) from the rear heater-A/C wire harness connector (5).
25. Remove the two bolts (4 and 10) that secure the rear heater-A/C housing (1) to the right inner quarter panel (7) and remove the housing.
Rear HVAC Housing Installation
INSTALLATION
