Journey FWD L4-2.4L (2011)
8. From the "Vehicle View" screen, click on the "AMP" icon.
9. Select "Flash" from the "AMP View" screen.
10. With the cursor over the desired flash file, click the small green arrow button on the right side of the screen.
11. From the "AMP View" screen follow the wiTECH screen instructions to complete the flash.
12. Once the flash is complete click the "OK" button on the "ECU Flash: AMP" pop-up screen.
13. From the "Clear Stored DTCs" pop-up screen, click on the "Clear DTCs" button.
14. After the "Clear Stored DTCs" pop-up screen disappears, verify the part number (displayed at the end of the "Current ECU Flash Number"
statement) has been updated to the new part number. If it has been updated, then the flash has been completed successfully.
If the flash was interrupted or failed, repeat the reprograming procedure.
15. Turn the ignition to the "OFF" position, remove the wiPOD and battery charger from the vehicle.
