Journey FWD V6-3.5L (2009)
-
Using the wiring diagrams as a guide, repair the (L1) Backup Lamp Feed circuit for an open.
-
Perform the BODY VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test.
3. (Z913) GROUND CIRCUIT
1. Turn the ignition off.
2. Measure the resistance between ground and the (Z913) Ground Circuit.
Is the resistance below 10.0 Ohms?
Yes
-
Go To 4
No
-
Using the wiring diagrams as a guide, repair the (Z913) Ground circuit for an open.
-
Perform the BODY VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test.
4. CAMERA SIGNAL, RETURN, AND SHIELD CIRCUITS OPEN
1. Disconnect the Radio C3 harness connector.
2. Measure the resistance of the (X970) (X971) and (X972) circuits.
Is the resistance below 10.0 Ohms on the (X970) (X971) or (X972) circuits?
