Journey FWD V6-3.5L (2009)
Steering Mounted Controls Communication Module: Service and Repair
Steering Column Control Module - Removal
REMOVAL
SCCM
1. Place the front road wheels in the STRAIGHT-AHEAD position.
2. Open hood.
3. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, personal injury or death.
4. Remove steering wheel See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Removal.
5. Remove upper and lower steering column shrouds to gain access to the Steering Column Control Module (SCCM)See: Steering and
Suspension/Steering/Steering Column/Steering Column Cover/Service and Repair/Steering Column Shroud - Removal.
6. Lock the clockspring rotor in the center position as follows: Insert a grenade pin through the hole in the rotor at the 10 o'clock position.
7. Remove the three screws (1) to the Steering Column Control Module (SCCM) (3).
8. Disconnect the electrical connectors (2) between the SCCM (1) and the instrument panel wiring harness at the base of the SCCM and remove from
column.
NOTE: If only removing the SCCM from column, there is no need to continue to next step.
DISASSEMBLY
