Journey FWD V6-3.5L (2009)
Cowl Moulding / Trim: By Symptom
Technical Service Bulletin # 23-027-08
Date: 080906
Body - Cowl Panel Gap At Windshield/Wind Noise
NUMBER: 23-027-08
GROUP: Body
DATE: September 6, 2008
SUBJECT:
Cowl Panel Screen Gapping From Windshield
OVERVIEW:
This bulletin involves inspection and installation of an additional cowl screen push-pin.
MODELS:
2009
(JC)
Journey
NOTE:
This bulletin applies to vehicles between January 2, 2008 (MDH0102XX) and April 30, 2008 (MDH0430XX).
SYMPTOM/CONDITION:
The customer may experience one or more of the following conditions:
^
Wind noise from lower windshield and cowl screen panel center area at highway speed.
^
Cowl screen panel gapping or warping from windshield at center area.
DIAGNOSIS:
1.
Inspect the cowl screen panel center section, for gapping from the windshield.
2.
Is the gap 2 mm (0.078 in.) or greater?
a.
Yes >>> Perform the Repair Procedure.
b.
No >>> Repair procedure does not apply. Further diagnosis required.
PARTS REQUIRED:
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE:
1.
Remove the inner cowl screen from the vehicle. Refer to the detailed removal procedures available in DealerCONNECT > TechCONNECT under:
Service Info > 23 - BODY > EXTERIOR > COVER, Cowl Panel, Inner > REMOVAL.
