Journey FWD V6-3.5L (2009)
5. Position backlite in center of liftgate opening and resting on the side and lower spacers.
6. Apply adhesive tape strips (1) around the perimeter of the liftgate opening to aid in installation.
NOTE: Windshield installation shown, backlite similar.
7. Verify the backlite gap is parallel to with the liftgate opening.
8. Cut tape with a sharp knife and remove backlite.
NOTE: Typical primer installation shown.
9. Clean and dry area of glass (2) to be re-glued with a suitable glass preparation solvent and rag.
10. Using a flash light, verify that glass primer is without damage.
11. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
