Journey FWD V6-3.5L (2009)
NOTE: Windshield opening shown, liftgate opening similar.
3. Clean and dry area of liftgate opening to be re-glued with a suitable glass preparation solvent and rag.
4. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
5. Allow primer to air dry for at least 10 minutes.
Backlite Installation
1. Apply bead of adhesive (1) with a triangular nozzle directly to the backlite seal starting at bottom in center of the backlite.
CAUTION: Always apply bead of adhesive to the backlite. Always install the backlite within 5 minutes after applying adhesive.
2. Bead dimensions should be approximately 9.5 mm wide (1) by 12.7 mm in height (2).
