Journey FWD V6-3.5L (2009)
2.
Drill a 13 mm (0.511 in.) hole in the inner cowl panel lower screen at the location shown (Fig 1).
3.
Cut and remove a 14 mm (0.551 in.) section of foam from the airbox at the location shown (Fig. 2).
4.
Install the inner cowl panel lower screen but do not install the wiper arms or outer cowl panel top screen. Refer to the detailed installation
procedures available in DealerCONNECT > TechCONNECT under: Service Info > 23 - BODY > EXTERIOR > COVER, Cowl Panel, Inner >
INSTALLATION.
