Journey FWD V6-3.5L (2009)
5. Apply bearing grease (supplied with part) to sensor head shaft and O-ring.
CAUTION: Ensure that sensor mounting surface on bearing is clean before sensor installation.
6. Pass the wheel speed sensor head through the hole in the brake shield, then push it into the mounting hole in hub and bearing (3) and align the
mounting screw hole.
7. Install a NEW mounting screw (2). Tighten the mounting screw to 6 Nm (55 in. lbs.).
8. Install the wheel speed sensor routing clip (4) in the brake tube routing bracket (1).
9. Install the wheel speed sensor cable into the routing clips (3) above the trailing arm.
10. Install brake rotor as well as all components necessary to access it. See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation
11. Perform the ABS Verification Test and clear any faults. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/ABS Verification Test