Journey FWD V6-3.5L (2009)
CAUTION: When removing or installing a caliper guide pin bolt, it is necessary to hold the guide pin stationary while turning the bolt. Hold
the guide pin stationary using a wrench placed upon the pin's hex-shaped head.
3. Remove two caliper guide pin bolts (1).
4. Remove the disc brake caliper (2) from the disc brake adapter bracket (3) and hang it out of the way using wire or a bungee cord. Use care not to
overextend the brake hose or parking brake cable when doing this.
5. Remove the brake pads (2, 5) from the caliper adapter bracket (3).
Front
INSTALLATION
NOTE: Perform 1 through 5 on each side of the vehicle to complete pad set installation, then proceed to 6.
NOTE: Make sure that the audible wear indicator (if equipped) is placed toward the top when the inboard brake pad is installed on each side
of the vehicle.
